Instructions for Use

Thank you for choosing a high-quality 3DSMU product.

Preparation & Handling

• Before removing the product from its supports or handling it in any way, immerse it in lukewarm water (approximately 35-40°C / 95-105 °F) for 5-10 minutes.
• You may repeat this treatment before any later finishing or assembly stages if needed.
• Always handle the product and tools with care.

Assembly & Finishing

• When removing supports, use sharp cutting tools or a fine hobby saw.
• For surface finishing, use standard scale modeling tools.
• Apply primer with suitable materials and equipment before painting.
• If you use water-resistant paints, you can re-soften the product in warm water even after painting - always follow the paint manufacturer's instructions.

Safety Instructions

• Protect your eyes from small fragments and debris.
• If using power tools, ensure adequate ventilation and protect your respiratory system from resin dust.